alexandros_vagenas a écrit :
>
> Hi everyone,
>
> This is my first post here as I just got a used An1x.
>
> When I first turned it on and started going through the presets, I
> realised that on the poly single sounds, after I had played a few
> notes, there was a gap when no sound would be produced when I pressed
> down on the keys. Then it would resume after a few seconds. This would
> be recrified if I turned the layer from single to dual but I'm looking
> for a permanent solution.
>
> The AN1x hadn't been used in years and I imagine that's part of it. Do
> you know if there's something simple I can check on the circuitboard?
> I'm not familiar with electronics at all.
>
> Thanks,
>
> Alex
>
Hi Alex,
i never had this kind of problem.
In "poly single" mode you have the full polyphony on the whole keyboard
and normally you can't miss notes, having 10 fingers as most human
beings have.
First try to perform a full factory reset . OK, you'll loose the sounds
you have in your synth, but on another hand factory sounds are service
proven.
Do you have a "battery low" message when you turn your AN1x on?
Cheers
J.F.
>
>