--- In
AN1x-list@yahoogroups.com, "alexandros_vagenas" <alexandros_vagenas@...> wrote:
>
> Hi everyone,
>
> This is my first post here as I just got a used An1x.
>
> When I first turned it on and started going through the presets, I realised that on the poly single sounds, after I had played a few notes, there was a gap when no sound would be produced when I pressed down on the keys. Then it would resume after a few seconds. This would be recrified if I turned the layer from single to dual but I'm looking for a permanent solution.
Welcome to AN1x-list, congrats on the new synth.
Never heard of this specific issue, but I would ask if you checked the Portamento value to determine if it was set to an extreme value that would result in what could perceived as an abnormal lag in between note ons.
>
> The AN1x hadn't been used in years and I imagine that's part of it. Do you know if there's something simple I can check on the circuitboard? I'm not familiar with electronics at all.
>
It's not uncommon for the ribbon connectors for the controllers to become unseated or loose after shipment or long periods of disuse.My suggestion is to a) perform a factory reset if you've not already and b) open the case (with some patience and a screw driver) and reseat all the cable connectors to the main board.
regards,
Jon