Ok Edwards and thx :)
--- In
AN1x-list@yahoogroups.com, "Ed Edwards" <edward.edwards@...>
wrote:
>
> Ok Mark, you found one of the mysteries of the AN1x...
>
> This topic has been discussed a lot, but I think that there is no
exact
> answer. Some patches the control returns to the original value
when you
> lift your finger. Some patches it stays at the new level.
>
> Jon, our list moderator, might have some deeper knowledge. I think
he (or
> some other genius) was able to discover something logical about how
to set
> it up in the matrix.
>
> ...or maybe not. Anyone?
>
>
>
>
> > -----Original Message-----
> > From: AN1x-list@yahoogroups.com [mailto:AN1x-
list@yahoogroups.com] On
> Behalf
> > Of marcobasile78
> > Sent: Tuesday, May 06, 2008 9:27 AM
> > To: AN1x-list@yahoogroups.com
> > Subject: [AN1x] Question Abut The Ribbon
> >
> > Hallo everybody...here is mark from Naples
> > A little question...when i set a ribboin X in control Matrix (to
cotrol
> > for example the cutoff), and then i pass my finger on it, i
noticed
> > that the value of the parameter assigned don't return on the
original
> > position of the patch but remains on the lower value...
> > for example
> > The cutoff value is 65...then i pass my finger on ribbon and when
i
> > rise up it the value don't returns on 65 but returns on a low
value...
> > what's my mistake?
> > thanx
> >
> >
> > ------------------------------------
> >
> > Community email addresses:
> > Post message: AN1x-list@yahoogroups.com
> > Subscribe: AN1x-list-subscribe@yahoogroups.com
> > Unsubscribe: AN1x-list-unsubscribe@yahoogroups.com
> > List owner: AN1x-list-owner@yahoogroups.com
> >
> > Shortcut URL to this page:
> > http://groups.yahoo.com/group/AN1x-list
> >
> > The AN1x Control Synthesizer FAQ::
> > http://www.geocities.com/jondl_2000/an1x_faq/an1x_faq_toc.htm
> > Yahoo! Groups Links
> >
> >
> >
>