Ok Mark, you found one of the mysteries of the AN1x...
This topic has been discussed a lot, but I think that there is no exact
answer. Some patches the control returns to the original value when you
lift your finger. Some patches it stays at the new level.
Jon, our list moderator, might have some deeper knowledge. I think he (or
some other genius) was able to discover something logical about how to set
it up in the matrix.
...or maybe not. Anyone?
> -----Original Message-----
> From: AN1x-list@yahoogroups.com [mailto:AN1x-list@yahoogroups.com] On
Behalf
> Of marcobasile78
> Sent: Tuesday, May 06, 2008 9:27 AM
> To: AN1x-list@yahoogroups.com
> Subject: [AN1x] Question Abut The Ribbon
>
> Hallo everybody...here is mark from Naples
> A little question...when i set a ribboin X in control Matrix (to cotrol
> for example the cutoff), and then i pass my finger on it, i noticed
> that the value of the parameter assigned don't return on the original
> position of the patch but remains on the lower value...
> for example
> The cutoff value is 65...then i pass my finger on ribbon and when i
> rise up it the value don't returns on 65 but returns on a low value...
> what's my mistake?
> thanx
>
>
> ------------------------------------
>
> Community email addresses:
> Post message: AN1x-list@yahoogroups.com
> Subscribe: AN1x-list-subscribe@yahoogroups.com
> Unsubscribe: AN1x-list-unsubscribe@yahoogroups.com
> List owner: AN1x-list-owner@yahoogroups.com
>
> Shortcut URL to this page:
> http://groups.yahoo.com/group/AN1x-list
>
> The AN1x Control Synthesizer FAQ::
> http://www.geocities.com/jondl_2000/an1x_faq/an1x_faq_toc.htm
> Yahoo! Groups Links
>
>
>