I'll answer my own question, if I may! [:)]
Since posting my query, I was looking around the files section of this
list, and under Tips and Tricks I found Using an Assign Knob
for Data Entry by Jon Levinson, which was exactly what I was looking
for! I now have Assignable Knob 8 setup to do this.
Thanks, Jon!
Cheers
Derek
--- In
AN1x-list@yahoogroups.com, "derek192603" <dacook.sa432bb@...>
wrote:
>
> Hi, After having my AN1x for a little while, I'm now thinking about
> getting into editing it, and I have a question, which I can't find the
> answer to in the manual, unless I'm being thick! [:)]
>
> I'll ask my question by an example: there's a patch I'm looking to
edit
> which has the delay effect unit set up as LCR delay, with delay
settings
> of 600ms and I want to make that much shorter. Whilst I've know you
use
> the matrix and associated buttons for incrementing and decrementing
> those delay values, it takes ages for the parameters to adjust whilst
> just holding down the relevant matrix button. And Life's too short to
> wait for the inc/dec on the matrix buttons at the rate they go at!
[:)]
>
> What I'm missing is a way to enter in a value directly (e.g. typing in
> 200 on the keypad for a 200ms delay, which I can do on my EX5), or
using
> one of the knobs to set the value. But typing on the AN1x keypad just
> seems to change the patch.
>
> Any advice appreciated. Is what I want to do even possible?
>
> Cheers
> Derek
>
>
>
>
>
> [Non-text portions of this message have been removed]
>
[Non-text portions of this message have been removed]