--- In
AN1x-list@yahoogroups.com, "schmaltzberger" <docbell@...> wrote:
> I suspect this maybe where I am going wrong.. I have the an1x plugged
> into a single channel on my tascam fw1804 interface. I have a stereo
> out cable that goes from the synth to a single input to plug into my
> interface.
It sounds as though you are using a Send/Return (Insert Cable) wired: TIP = Send, RING =
Return. These are often used as a "Y" to split stereo signal into Left and Right (Right =
RING and Left = TIP.) This type of cable is typically not used in the manner in which you
have it connected.
You need to connect the cable to the Left output of your AN1x and connect the Left
connection (TIP = Send) into your FW1804. Do not use the Right connection RING =
Return.) This will provide you a mono connection from your AN1x to your FW1804.
Alternately, you could connect the cable to the headphone out of your AN1x and run the
split outputs into two channels on your FW1804.
This should address your issue.
Jon