Thank you for your replies and your hint to the table with the parameters!
I have captured the sysex-commands from the An1x-Editor with (the
great tool) Bome's Midi Translator (and MidiYoke); With the Translator
I can control the synth now via normal Midi-CC from my sequencer. It
is really great.
I have written a howto for the sequencer I am using (Renoise), it
should be applicable for others as well:
http://www.renoise.com/board/index.php?showtopic=11777Kind regards,
Thilo
--- In AN1x-list@yahoogroups.com, "tidda_adda" <acjiskoot@...> wrote:
>
> Of course you can change all these parameters with MIDI.
> Look in MIDI Data Table <1-3> "MIDI Parameter Change Table (Current
> Voice Common Buffer" on page 14 of the Data List manual.
>
> Tidda
>
>
> --- In AN1x-list@yahoogroups.com, Jeff <jf.serviere@> wrote:
> >
> > Hello !
> > as far as i know the effects section parameters are not
addressable by
> > MIDI but can only be assigned to the own controls of the AN1x (pots,
> mod
> > wheel and so on...) . It has to be done for each patch . I use to
> > control the "leslie" speed with the mod wheel and the reverb and
delay
> > with 2 knobs, i never tried the ribbon controller (used mostly to
> > control the cutoff and resonance of the filter together). The pedal
> > controller (neither the footswitch nor the volume) should work too .
> > OK, this cannot be done by a software sequencer ....
> > @+
> > J.F.
> >
> > thilo_78 a écrit :
> >
> > >Hello,
> > >
> > >I would like to control some parameters of the effects-section via
> > >Midi. For example I would like to control Delay's "FB-Level" or
"Delay
> > >Return", "Reverb Return" etc.
> > >In the Midi-Control Chart I did not find an entry. Is there a
> > >possibility to control these parameters (e.g. by routing it to
ribbonX
> > >or another controller; or via sysex messages)??
> > >
> > >Thank you very much and kind regards,
> > >
> > >Thilo
> > >
> > >
> > >
> > >
> > >
> > >---
> > >avast! Antivirus: message Entrant propre.
> > >Base de donnÚes des virus (VPS): 000729-2, 31/03/2007
> > >Test du: 02/04/2007 00:42:27
> > >avast! - copyright (c) 2000-2007 ALWIL Software.
> > >http://www.avast.com
> > >
> > >
> > >
> > >
> > >
> >
> >
> >
> > ---
> > avast! Antivirus: message Sortant propre.
> > Base de donnÚes des virus (VPS): 000729-2, 31/03/2007
> > Test du: 02/04/2007 01:08:14
> > avast! - copyright (c) 2000-2007 ALWIL Software.
> > http://www.avast.com
> >
>