I replaced the battery and did a full reset. Still no
help with the scene buttons/matrix row selection. I
also tried pressing the solder joints, they all seemed
ok. I checked all ribbons and wires I could find with
the same results. Any more ideas?
The diagnostics runs fine except for when it says
'scene' because obviously, the button isn't
responding. At that point I have to power down.
Any suggestions on how to find a reasonable repair
facility? Will Yamaha service this? I'm near Chicago
if that helps. Any idea what I can expect to pay? Any
idea what could be causing this sort of problem?
I haphazardly bought this knowing full well that it
wasn't responding like it should but my want
overwhelmed my logic. I spent $200 on it, which is I
suppose what they cost fully functioning. I'm
typically very good at getting deals. This time, I was
on the wrong end.
I bet I could sell it broken for $150 and buy another
one for $250 and end up loosing $100 on my original
purchase. That being said, I don't want to spend more
than $100 on repairs.
Thanks everybody, you've all been really kind and
helpful.
-jesse
____________________________________________________________________________________
Now that's room service! Choose from over 150,000 hotels
in 45,000 destinations on Yahoo! Travel to find your fit.
http://farechase.yahoo.com/promo-generic-14795097