Greetings:
Just for kicks, make sure your power adapter A) is the correct one, B)
it didn't die on you,
C) the cord, jack, etc, are good.
This does happen all of the time and it could just be coincidence here.
Generally, even
after a bad update, it is not totally dead as you say.
This was an issue with a perfectly good AN1x a while ago. That went
around in circles
in the group until I just said, "Sounds Like a bad Power Adapter" -- It
was. All is well.
Give it a look. Maybe replace or try a substitute anyway -- 12V DC
Center Positive.
Regards;
Peter
Jon wrote:
> --- In AN1x-list@yahoogroups.com <mailto:AN1x-list%40yahoogroups.com>,
> "parmastuff" <rszwec@...> wrote:
> >
> > yeah, I followed the instructions - didn't touch the unit while it
> was updating, pressed
> the
> > right buttons, etc. - but now it won't even power up! so I can't try
> the update again
> > because the unit won't respond at all
>
> 7) Press and hold the [SONG], [PATTERN], and [EXIT] buttons on the
> AN200, then turn ON
> the power. The following version messages will be displayed: 'nrML' /
> '1.030' / 'krnL' /
> '0.500' / 'PLG' / '1.05'
>
> So at Step 7, the version message never appears when you power ON
> while holding
> [SONG], [PATTERN], and [EXIT]? You might want to cross post your
> question to the DX200
> list here at Yahoo! Groups to see if anybody has experienced this.
> Otherwise, sounds like a
> service center visit may be the right call...
>
> 8) Turn the power OFF.
>
> 9) Press and hold the [SHOW VALUE], [PATTERN], and [EXIT] buttons on
> the AN200, then
> turn ON the power to execute the Factory Reset. This will take about
> 20 seconds.
>
>
--
Best regards,
Peter C. Bye III 3M Corporation
Managing Specialist, HPC Systems; 3M Center, Bldg 42-5-E08
High Performance Computing St. Paul, MN 55144-1000
Engineering Information Technology 651 778 5218
3M Research & Development 612 720 1477 (Cell)
pcbye@... (SMTP Mail) 651 575 8299 (FAX)
pcbye2@... (Lotus Notes)
"Pound for pound, the Amoeba is
the most vicious animal on Earth"
Confidentiality Note: This message is intended only for the named
recipient and may contain confidential, proprietary or legally
privileged information. Unauthorized individuals or entities are not
permitted access to this information. Any dissemination, distribution,
or copying of this information is strictly prohibited. If you have
received this message in error, please advise the sender by reply
e-mail, and delete this message and any attachments.
[Non-text portions of this message have been removed]