--- In
AN1x-list@yahoogroups.com, "parmastuff" <rszwec@...> wrote:
>
> yeah, I followed the instructions - didn't touch the unit while it was updating, pressed
the
> right buttons, etc. - but now it won't even power up! so I can't try the update again
> because the unit won't respond at all
7) Press and hold the [SONG], [PATTERN], and [EXIT] buttons on the AN200, then turn ON
the power. The following version messages will be displayed: 'nrML' / '1.030' / 'krnL' /
'0.500' / 'PLG' / '1.05'
So at Step 7, the version message never appears when you power ON while holding
[SONG], [PATTERN], and [EXIT]? You might want to cross post your question to the DX200
list here at Yahoo! Groups to see if anybody has experienced this. Otherwise, sounds like a
service center visit may be the right call...
8) Turn the power OFF.
9) Press and hold the [SHOW VALUE], [PATTERN], and [EXIT] buttons on the AN200, then
turn ON the power to execute the Factory Reset. This will take about 20 seconds.