--- In
AN1x-list@yahoogroups.com, "quivzzz" <okjae.koo@...> wrote:
>
> hi, i got serious problem with my an1x
> vcf cutoff automatically go up to very high value.
> i found that if i turn off ribbon control, everything's fine.
> but ribbon is one of my favorite feature of an1x.
>
> did anyone had similar experience before?
> can i clean the inside of ribbon to work properly?
In the Ctrl Matrix, under the VOICE/SCENE SETUP menu, what is the value for Depth
parameter? If it is set to 'dirct' that would account for the wide range in value for the VCF
Cutoff. Change the Depth parameter to a '+' or '-' value and this will be an offset from the
VCF Cutoff value saved in your Voice.
If this fails to address the problem, then you will want to open your AN1x case and check
the internal ribbon cable connector for the Ribbon Controller is affixed to the main board
securely.
Regards,
Jon