Hello,
all u really need is to look at page 9 of the Data list manual
and make sure that your AN1X is in mode 2
and NOT in mode 1
(at page 96 of the Owner's manual how to do it)
My personal fav would be
VCF cutoff VCF res Vca A Vca D Vca S Vca R
Lfo1 speed Lfo2 speed Vco Fmdepth Rev Chor Delay
but it always depends on a specific patch, a generic setup like this
can not always be useful but a good starting point
Regards
--------------------------------------------------Env1-----Env2--Env3-----------
Andrea.TONI@... Vco1 \ | | \
Solar System Missions (Sci-Sm) Vco2-->--Vcf-->Vca-->Ducati996
www.rssd.esa.int Vco3 / | | /
--------------------------------------------------Lfo1-----Lfo2--Lfo3-----------
From: "fai31188" <
fai31188@...>
Subject: Assignable Knobs
Hello everyone. I am enjoying my board, but, can't say I am using it
to its fullest potential. I was turning knobs yesterday and realized
that I don't have my 8 assignable knobs assigned to anything. I know
this may be a ridiculous question, but, I am looking for suggestions
for assigning parameters to these knobs. I am a noob when it comes to
synthesis, so, parameters that would change the sound of the patch in
real time would be ideal!!