--- In
AN1x-list@yahoogroups.com, "Bob S." <tttsystems@...> wrote:
>
> I don't actually have an AN1x yet (although I might have been
bidding on this one that has a problem) but most keyboard mechanisms
in synths are connected to the scanning circuit or main board via a
removable cable/connector. If you have any DIY desires, you can
open the unit and see if the cable has become unseated or broken
during shipping to ?France?
>
> Bob
> Corona/Riverside, CA
This is a very good suggestion and I would second the idea. It's
not difficult to open the AN1x case - simply remove the plastic
knobs on the front panel, flip it over and remove the approximately
40 screws to remove the case cover.
This very topic has been discussed on the list previoulsy, although
not recently (search the list archives), and it was determined a
cable connector had become loose in transit. A similar problem has
cropped up from time to time affecting the Ribbon Controller too -
same fix is applicable.
Regards,
Jon