[sdiy] Oberheim Elma knobs

[Tom Wiltshire]

I found the same thing when I went looking for knobs to match an old Carlsbro amp I have. The collet knobs are still available (not bad 50 years later!) but the skirts are much more difficult.

> On 26 May 2025, at 09:33, mark verbos via Synth-diy <synth-diy at synth-diy.org> wrote:
> 
> These are available. Where you will have a problem is the skirts with arrow on them. I needed some for Marshall Time Modulators and got them on ebay. All the other parts, which are used on EMT gear, are easily available, but they are not cheap. 
> 
> 
> Mark
> 
> 
> 
>  
> 
>> On May 25, 2025, at 21:25, TERRY SHULTZ via Synth-diy <synth-diy at synth-diy.org> wrote:
>> 
>> https://www.newark.com/elma/020-3520/knob-14-5mm/dp/01M9603?CMP=AFC-OP <https://www.newark.com/elma/020-3520/knob-14-5mm/dp/01M9603?CMP=AFC-OP>
>> 
>> These may be still available.
>> 
>> Checking next week to see if they are still available.
>> 
>> Regards,
>> 
>> Terry
>> ________________________________________________________
>> This is the Synth-diy mailing list
>> Submit email to: Synth-diy at synth-diy.org
>> View archive at: https://synth-diy.org/pipermail/synth-diy/
>> Check your settings at: https://synth-diy.org/mailman/listinfo/synth-diy
>> Selling or trading? Use marketplace at synth-diy.org
> 
> ________________________________________________________
> This is the Synth-diy mailing list
> Submit email to: Synth-diy at synth-diy.org
> View archive at: https://synth-diy.org/pipermail/synth-diy/
> Check your settings at: https://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20250526/073b378a/attachment.htm>