[sdiy] Vactrol projects

[Synth]

I have a low-parts vactrol VCF that uses a 5C2, and I think a 5C3 will work
(and give you faster response).
http://www.charlielamm.com/synth/vactrolvcf.php3

I will get extra PCB's if I do a run of these again, but at the moment no
ETA.

I have a 5C3 based envelope follower:
http://www.charlielamm.com/synth/vactrolenv.php3

----- Original Message ----- 
From: "Louis van Dompselaar" <louis at dompselaar.org>
To: <synth-diy at dropmix.xs4all.nl>
Sent: Friday, February 02, 2007 5:35 AM
Subject: [sdiy] Vactrol projects


> So, I got the vactrols (four VTL5C3/2 and four VTL5C3), now
> what should I build with them?
>
> I've been looking at several options:
>
> - Build a Korg resonator.
>    Problem is that no-one seems to have done a PCB for that yet.
>
> - Build a Mutant Vactor Filter.  Very nice, but, again, no PCB.
>
> - Build the low pass gate found on fonik.de.
>    Usuable PCB design but that 3PDT centre-off switch is impossible to
find.
>
> - Build the original Buchla low pass gate.  I found a PCB by Mark Verbos
for
>    that that seems useable.
>
> Any suggestions for other projects?
>
> Louis
>