[sdiy] kog T3

[J. Larry Hendry]

----- Original Message -----
From: St Eric's... <sainteric at piramiden.demon.nl>
So maybe a better question would be; anyone who knows what connector needs
which voltage?

----
I'm not sure my e-mails are getting through to Eric, so I'll post here.  Or,
perhaps he is unable to respond to me.  Sorry for the public bandwidth.

Eric, I have one of these power supplies in my hand and can give you the pin
out detail.  If you are not able to e-mail me privately (stinkin' ISP is
bouncing some of my e-mail), you can also mail me at  hendrysr at yahoo.com

The one I have is the KLM-1374A which is the 100 - 117 volt versions for US
and Japan.  But, the output voltages should be the same.  It appears to
supply 4 voltages:  +5 for the processors and such, +/- 15 for the linear
stuff, and AC for the back light (probably 100 VAC).  I'll put some
resistors for load on the DC outputs and fire this puppy up and verify the
voltages.

Larry Hendry