[sdiy] SIP to DIP Conversion

[Seb Francis]

I assume the DIP is 8-pin.

How about a little piece of 8 strip wide stripboard.  Solder in the DIP, break the 4 tracks in the middle of the DIP, connect the far side 4 pins via jumper wires to the 4 end strips, solder in 8 little header pins along the near side edge.  Bob's your uncle?

Seb



BrightBoy wrote:

> Does anyone know of a vendor that makes an adapter
> that will allow an 8-pin SIP (Single Inline) IC
> to be replaced with a 8-pin Dip (Dual Inline) ????
>
> I have a Yamaha CS-15 that has a dead 8-pin
> SIP op-amp.  The replacement that Yamaha sent
> me was the DIP Version of the same op-amp....
>
> You can see my dilemma....
>
> Cheers,
>
> Jeff R. Dec

--

*======================*
 p: +44 (0)1242 694 123
 m: +44 (0)7876 020 587
*======================*