[sdiy] Paia Ekx10 ADSR questions

[greg montalbano]

First question:  do you have the documentation that came with it?
As I recall (it's been a few years), it explains pretty much everything.
The front panel can be whatever you like (part of the point of those old
"experimenter's kits"), but there is a suggested basic panel shown in there
somewhere.

If you don't have the docs, let me know, and I'll dig into my old files for 
a copy.

~GMM

At 05:03 PM 5/8/02 -0400, you wrote:
>     My friend recently gave me an old Paia Ekx-10 ADSR kit. Its based around
>a CEM 3310 chip. I had no problem assembling the board, but I'm a bit
>baffled as to how to wire it up to the panel.
>     On the lower part of the board there is a row of pads that I assume are
>for the jacks but I'm not 100% sure. There are also single pads spaced
>around the board with the letters A, B, C, L. They are reffered to as
>"summing nodes." I have NO CLUE what this means. I only hve experience in
>assembling MOTM kits which are known for there "fool-proof" instructions, so
>you can imagine this little Paia is confusing me a bit. Can anyone shed some
>light on this and/or maybe give me an idea what the front panel should even
>look like?
>
>                         Thanks,
>                         John