[sdiy] digital noise: protoboard vs solder breadboard

[Paul Maddox]

All,

  I've had NO problems mixing analog and digital on Stripboard....
Take a look atthe prototype monowave insides ;-
http://www.modulus.wavesynth.com/monowave/prototype.htm
 The board at the back of the case is almost 16" wide, has a whole pile of
digital stuff on and some analog too..

 Just my two peenies worth...

Paul
______________________________________________
"I've seen the light at the end of the tunnel, And its blue!'

Wavesynth home page;-
    Http://www.wavesynth.com
Modulus synthesizers home page;-
    Http://www.modulus.wavesynth.com
PPG Synthesizer pages;-
    Http://www.PPG.wavesynth.com


----- Original Message -----
From: "Toby Paddock" <tpaddock at seanet.com>
To: <synth-diy at dropmix.xs4all.nl>
Sent: Wednesday, February 27, 2002 3:10 PM
Subject: Re: [sdiy] digital noise: protoboard vs solder breadboard


> And there big differences in quality of the plastic
> protoboards. I've had good luck with some and BAD
> luck with others. They would lose their *spring*
> and not make a solid connection and drive you nuts.
> The bad ones I had had a single row of holes down
> each side, like for power. I think from Radio Shack
> about 15 years ago.
>
> Later,
> Toby Paddock
>
>