[sdiy] s612-ax73 cable

[gregory zifcak]

i was assuming that in a shielded 6 conductor cable that each would be 
shielded. is this not the case?

greg


>From: "John L Marshall" <john.l.marshall at gte.net>
>To: "gregory zifcak" <zifcak at hotmail.com>, <jlarryh at iquest.net>,   
><synth-diy at dropmix.xs4all.nl>
>Subject: Re: [sdiy] s612-ax73 cable
>Date: Tue, 23 Oct 2001 16:06:00 -0700
>
>It is probably best that each conductor be individually shielded. With one
>common shield you are inviting crosstalk between the voices. Can you can
>live with crosstalk between the voices?
>
>John
>
>----- Original Message -----
>From: gregory zifcak <zifcak at hotmail.com>
>To: <jlarryh at iquest.net>; <synth-diy at dropmix.xs4all.nl>
>Sent: Tuesday, October 23, 2001 2:38 PM
>Subject: Re: [sdiy] s612-ax73 cable
>
>
> > thanks larry and atom,
> >
> > >Pin 1 = voice 3
> > >Pin 2 = voice 2
> > >Pin 3 = voice 1
> > >Pin 4 = common ground / shield
> > >Pin 5 = not connected
> > >Pin 6 = voice 6
> > >Pin 7 = voice 5
> > >Pin 8 = voice 4
> > >Pin 9 through pin 13 not used
> >
> > so i should just get shielded six conductor cable, two male connectors,
>and
> > connect the corresponding voice pins together, ignoring 4 and 9-13, 
>right?
> > or do i need 7 conductor to hook up pin 4 as well?
> >
> > greg
> >
> >
> >
> > >The outer metal part of the connector is also connected to ground.  
>That
> > >should help you locate pin 4 as they are shorted together.
> > >
> > >The cable does need to be shielded as it is low level audio.  All 
>signals
> > >are unbalanced.
> > >Larry Hendry
> > >
> > >
> >
> >
> > _________________________________________________________________
> > Get your FREE download of MSN Explorer at 
>http://explorer.msn.com/intl.asp
> >
>


_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp