Fw: [sdiy] ETI vocoder input amps

[UKB]

Hallvard,

I'll gladly have a look at it - I have the article already (except the main
PCB bits) and I have found your site.

I can't promise any miracles as I'm pretty new to electronics but you never
know - a fresh pair of eyes might stumble on something.....

Cheers

Paul
----- Original Message -----
From: Hallvard Tangeraas <northstar2010 at yahoo.no>
To: <synth-diy at dropmix.xs4all.nl>
Sent: 9 November 2001 08:38
Subject: Re: Fw: [sdiy] ETI vocoder input amps


> At 20:11 +0000  09.11.01, UKB wrote:
>
>
> >It sounds like you have had a long journey to get this far! I did find a
zip
> >file with the article in it, which I downloaded but the main board scan
was
> >corrupted and the traces were not usable.
>
> I sure did! Which makes it even more a pity not to complete it.
> Sorry to hear about the downloaded article, but read on as I think I
> can help...
>
>
> >If you could scan your copy with the fixes, that would be great but I
know
> >its a lot of work.
>
> Tell you what... if you figure out a way to get the input amps working
> I'll gladly make the whole article available including circuit layouts
> and all.
> How about it? I believe I've stared too long at the input amp
> circuitry, and although the schematic is still wrong (I can't exactly
> figure out why as I've studied pin layouts/descriptions of the ICs
> used, but I'll take a look again) I can't see in practical terms what
> may be wrong with the actual PCB.
> I could really use some practical help here.
>
>
> Hallvard
> --
> Notator/Creator SL : <http://www.notator.org>
> Atari Launchpad    : <http://launchpad.atari.org>
>