[sdiy] ARP->MODULAR was : Question on pot substitution

[TooManySynths]

Thanks for the advice. I didn't think it would be an
issue in the cases I am considering there use, but
wanted to make sure I wasn't overlooking something.

Tonights project:

Oddysey with 5 mangled sliders becomes a panel with
2*VCO, 1*VCF, 1*VCA, ADSR, AR, and LFO. It's mostly
drilling with a little soldering.

I know people have modded oddyseys, but has anyone
else gutted one for a diy modular project?  Any good
mods that would be easier to do now, than later? 

Thanks Again
Daryl

PS: by tommorow morning I should have a bunch of
oddysey sliders (minus the five mangled ones) for
sale/trade if anyone wants em :)


--- Theo <t.hogers at home.nl> wrote:
> 125k is quite close to 100k.
> And in 99 out of hundred cases there will be no
> problem anyway, even if the
> value differs a bit more.
> A possible side effect could be a slightly altered
> input impedance, but this
> is about the worse that may happen.
> So go ahead and use them.
> 
> Theo
> 
> 
> 
> From: TooManySynths <p8051 at yahoo.com>
> 
> > Hi All,
> >
> > I am building/converting several projects for
> modular
> > use and I have a question regarding pot values.
> > Almost all schematics call for 100k linear pots on
> the
> > cv inputs.  I have a boatload of 125k linear pots
> and
> > was hoping to use them.  Specifically, how will
> this
> > affect performance of cv inputs.
> >
> > Thanks
> > Daryl
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Make international calls for as low as $.04/minute
> with Yahoo! Messenger
> > http://phonecard.yahoo.com/
> 


__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/