"Vectrone" Patch - Mike Fisher

Classic VCO

Sine output to X2 of Mixolator #1
Pulse output to Y of Mixolator #2
Saw output to Y of Mixolator #1
PWM set all the way up
Pulse set at about 12o'clock

Sequantizer

10v output (non-quantized) to ENV input of WC
Steps 1-8 tuned to trigger different table points on WC

Dual Envelator

+Out of Envelope 1 to Zmod of Mixolator #1
-Out of Envelope 1 to multiple: to FC1 of Omni Filter, to PWM of Classic VCO
SQR out of Envelope 1 to Gate input of WC
END out of Envelope 1 to Multiple: to Sequantizer step input, to Gate of Envelope 2
+Out of Envelope 2 to Zmod of Mixolator #2
Attack and Decay of Envelope 1 set about 10o'clock
Envelope 1 mode = cycle
Attack of Envelope 2 is set to full clockwise position
Decay of Envelope 2 is set to approx 8o'clock
Envelope 2 mode = AD

Waveform City

VCA output to X1 of Mixolator 1
Wave knob set to full counter-clockwise position
ENV knob set to full clockwise position
Attack set to approx 1o'clock
Release set to approx 2o'clock
Synch set to approx 1o'clock
Bank 8 selected

Omni Filter

12db output to X1 of Mixolator 2
Coarse knob set to approx 1o'clock
FC1 set to approx 3o'clock
Mode = AP (All-pass)
Q set to approx 1o'clock
Add switch set to "On"

Dual Mixolator

X+ output from Mixolator 1 to IN1 of Omni Filter
X- output from Mixolator 2 to WC Synch input
X+ output from Mixolator 2 to amplifier, speaker, etc.
(this is the main output)

X1 of Mixolator 1 is set to approx 12o'clock
X2 of Mixolator 1 is set to approx 3o'clock
Y of Mixolator 1 is set to approx 10o'clock
Z of Mixolator 1 is set to 12o'clock
Lin/Log of Mixolator 1 is set full counterclockwise (Linear mode)

X1 of Mixolator 2 is set to approx 1o'clock
Y of Mixolator 2 is set to approx 10o'clock
Z of Mixolator 2 is set to 12o'clock
Lin/Log of Mixolator 2 is set full counterclockwise (Linear mode)


Notes:
If voltage control of pitch is desired, 1v/Oct goes to Classic VCO and Waveform City
Bank 8 is used for this example but any bank will produce interesting results
The speed of the vectoring (such that it is) is set by A and D knobs of Envelope 1
Sequantizer is "tuned" manually so as to trigger different waveforms on the WC
Oscillators were set to "high" pitch mode for the example, but would probably also produce interesting results in "low" mode.