Digital BW, The Print

Hi Joost,

thanks for the reply, guess I should have given a bit more info; I 
intend to be using QTR and an X-Rite Pulse Spectro.

I'm curious about your mention of the LK ink being idle when using 
QTR (have you produced your own curves for UT-3D with QTR?)

Jamie

--------------------------------------------------------------------

> Hi Jamie,

> I guess depends how you are going to drive them, via the Epson 
> driver or with a RIP?

> I use UT3D on the 2100 (7 inks) with QTR. I have the same ink 
setup 
> as you decribe plus the UT3D LK toner. However, that LK toner is 
> actually idle since QTR (or another RIP) doesn't use/need it. It's 
> only there to make the ink set compliant with the Epson driver.

> Joost

---------------------------------------------------------------------

> > Hello all,

> > I'am just about to have a go with the UT-3D inkset with a few 
> > printers and just wanted to check I've got the basic grasp of 
> things 
> > before I start.

> > Initially I'll try them in the R220 and was wondering if my 
choice 
> > of ink is correct:

> > Eboni
> > C
> > LC
> > M
> > LM
> > Y

> > then when I go to the R1800 and R2400 I will use the LK and the 
> LLK 
> > inks also.

> > I haven't seen much conversation regarding the R1800, is it a 
wise 
> > choice for a printer or is it likely to be problematic; I can 
see 
> > plenty of info on the R2400 but I'd prefer to leave that for 
> colour 
> > work at the moment if the R1800 is up to the job.

> > Any opinions on my choices would be greatly appreciated,

> > Jamie Creed