If it's the same one as the CS50/60 I have one.
Doug
synthparts.com
--- In yamahacs80@yahoogroups.com, "Quazimodo" <noddyspuncture@...> wrote:
>
> Personally Fernando, I think that your LDR is faulty - going off your findings. That is just a 20 ohm swing.
>
> Let me get round to it and I'll try and check the LDR in my CSY-1 that I am converting here. It should be the same. I do know LDR's are many and varied, so you will need the right one, but they are readily available.
>
> You're in no particular rush for this?
>
> Cheers,
> TOM
>
>
>
> --- In yamahacs80@yahoogroups.com, Fernando Zarone <fernandozarone@> wrote:
> >
> > Thanks;
> > I have done it, Tom,
> > after being disconnected, the light sensitive resistor varies from 195 Ohm (no pressure) to 175 Ohm (max pressure)
> > Is it correct in your valuable opinion?
> >
> > F
> >
> > Il giorno 01/mag/2012, alle ore 13:33, Quazimodo ha scritto:
> >
> > > With a meter on ohms. I would disconnect the LDR from the circuit whilst checking..!
> > >
> > > Cannot say what the spec should be but if there is no touch sense - there will be no meter movement...and there should be "some".
> > >
> > > Cheers,
> > > TOM
> > >
> > > --- In yamahacs80@yahoogroups.com, "papinje" <fernandozarone@> wrote:
> > > >
> > > > Hello.
> > > > the touch control in a SY 1 does not work. With TC sensitivity potentiometer at its maximum, the touch controlled effects go to the maximum, but are not modified by the key pressure.
> > > > Inside the machine, the lamp is lit, the "shield" moves well. What to check? How can I test the light variable resistor?
> > > > Every help is appreciatedÂ…
> > > > Fernando
> > > >
> > >
> > >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>