Thanks again David and Tom for the advice!
I was wondering about getting my trim pot adjuster in there with the
rack down. It might be a little tough in some areas where there are
loops of wires, but I think I may be able to do it.
Cheers,
Kent
On Apr 5, 2009, at 1:10 PM, David Rogoff wrote:
> omegacode80 wrote:
> > Thanks Tom! Is it really heavy when you're pulling it up? Is there a
> > spring mechanism that lifts it once you unscrew the bolts? I haven't
> > studied the anatomy of the side rails too carefully yet. Just opened
> > up the case and started looking around.
> >
> > I'm sure I'm gonna have to carefully make sure no cables get
> caught up
> > on anything.
>
> You might need to undo a couple of the heavy wires they use to hold
> the
> big cable bundles in place.
>
> HOWEVER..................
>
> As I finally realized after tuning CS80s for many years, if you're
> just
> doing the usual tuning procedure, you don't have to, and shouldn't
> raise
> the card frame! All the trimmers are accessible with it down. You just
> need a flashlight and to push the cable bundles up and out of the way.
> Leaving the cards down should make the temperature change less, so the
> tuning should hold better when you close up the lid.
>
> David
>
>
[Non-text portions of this message have been removed]