Thanks for that tip. Don't know why I didn't think of that as I've done that in a P5 before.
After swapping them and the problem stayed I decided to crank up the scope and check
the waveshaper and I believe that is the problem. Now I just need to find one of those!
Thanks,
Heath
--- In yamahacs80@yahoogroups.com, rj krohn <r_j_d_2.phila@...> wrote:
>
>
>
>
> 2. Voice 3 on Channel 2 is outputting only noise instead of a saw/square. Sine is
working
>
> well.
>
> when i had this problem, it was a bad VCO chip(153?). sine and noise are not generated
there. easiest way to tell is to swap the chip out for a working voice-be careful! the legs
on those types of chips are easy to bend putting them in and out of sockets. good luck-rj
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> [Non-text portions of this message have been removed]
>