I just did exactly that; removed all the wires from a voiceboard that I¹m
getting replaced. It isn¹t that bad. I had it cleanly out in less than 5
minutes. I imagine that soldering the new board in place won¹t be much more
difficult.
Jeroen
On 9/18/07 11:11 PM, "David Rogoff" <david@...> wrote:
> If you wanted to swap out the whole card, then yes, you'd have to change
> a few resistors. But no sane person would do that. You would just use
> the spare card as a source of parts to replace bad ones. I don't even
> want to think about moving all the wires from one board to another. It
> would have been nice if they had used connectors like the old Oberheim
> stuff, but that could have lead to a lot of cleaning of corroded connectors.
[Non-text portions of this message have been removed]