That should be easy enough to take care of. Just put a switch inline with the diode! Then you can switch it in and out easy...
----- Original Message -----
From: macsimski <simski@dds.nl>
To: PolySix@yahoogroups.com
Subject: [PolySix] simple vco hack for mixing sawtooth and pulse
Date: Sun, 02 Jan 2005 23:57:12 -0000
>
>
>
>
> Hello all.
>
> A few years ago i foud out that by cutting diode D1 on the synth board
> (upper left corner) you can mix the sawtooth and pulse signals. the
> diode cuts off the width of the pulse to zero when the vco is in
> sawtooth mode. Removing the diode leaves the width intact so the two
> signals are mixed.
>
> be careful!
>
> note that from then on, all previous memorized sounds sound different
> than before because the pulse width in memory is not supressed anymore.
>
>
>
>
>
>
>
>
> PolySix "Digiest" Page: http://www.acc.umu.se/~amber/Poly6
> Yahoo! Groups Links
>
>
>
>
.sig
-Chromatest J. Pantsmaker
http://www.chromatest.net