I was expecting to hear that. I'll check around as well but you're more savvy
than I. Are those specs in order? Please let me know if you find something
close.
dizz
Quoting The Old Crow <
oldcrow@oldcrows.net>:
>
> Actually, those pots might be hard to find. I'll have to see if I can
> locate the manufacturer. You might have to use a close-but-not-exact pot
> model.
>
> Crow
> /∗∗/
>
> On Tue, 14 Sep 2004 dizz@elitemofo.com wrote:
>
> > Thanks Crow,
> >
> > Yep, I'm thinking bad pot too. I'll try the measurements again. Can
> > you tell me where to get a replacement that's close to the original?
> > I've heard you mention jameco.com Looks like I need a 10K Ohm -5V to +5V
> > linear type correct?
> >
> > regards,
> >
> > dizz
> >
> > Quoting The Old Crow <oldcrow@oldcrows.net>:
> >
> > >
> > > Hm, that sounds like a pot with a cracked element. It will have to be
> > > replaced, unfortunately. You need to measure from the middle pot pin to
> > > ground to see the -5 to +5 volts.
>
>
>
>
> PolySix "Digiest" Page: http://www.acc.umu.se/~amber/Poly6
> Yahoo! Groups Links
>
>
>
>
>
>