Thanks Crow,
Yep, I'm thinking bad pot too. I'll try the measurements again. Can you tell
me where to get a replacement that's close to the original? I've heard you
mention jameco.com Looks like I need a 10K Ohm -5V to +5V linear type correct?
regards,
dizz
Quoting The Old Crow <
oldcrow@oldcrows.net>:
>
> Hm, that sounds like a pot with a cracked element. It will have to be
> replaced, unfortunately. You need to measure from the middle pot pin to
> ground to see the -5 to +5 volts.
>
> Crow
> /∗∗/
>
> On Tue, 14 Sep 2004 dizz@elitemofo.com wrote:
>
> > Crow,
> >
> > After cleaning the pot out with some contact cleaner the problem has
> > improved by appr. 50%. I believe it just hadn't been used in a while.
> > I finally got a decent DMM and measured the voltage on the pot.
> > However, I don't see any negative voltage unless I reverse the leads. It
> > reads 0V at minimum and sweeps up to 9.92V at the max rotation. In the
> > trouble spot, the meter reads "overload" briefly and quickly continues
> > measuring correctly after resuming the rotation. Any suggestions would
> > be greatly appreciated!
> >
> > dizz
>
>
>
>
> PolySix "Digiest" Page: http://www.acc.umu.se/~amber/Poly6
> Yahoo! Groups Links
>
>
>
>
>
>