if you trigger the lfo to frequency oscillation and adjust the lfo frequency to maximum, you will get also very heavy distorted sounds. and that sounds like the IC30/31 problem. but i discovered also other issues that effects the lfo. the cables from the board to the top the control board are very short. sometimes if i open my case they lost the contact and i get strange effects too
----- Original Message -----
From: toorglick
To: PolySix@yahoogroups.com
Sent: Monday, July 19, 2004 5:58 PM
Subject: [PolySix] Re: Son of a b∗∗∗∗
Yeah, it sounds more like the or ∗a∗ LFO gone haywire, but at a
frequency where it sounds more like distortion.
The only other conclusion I can come to is that I fried IC30 when
installing the new chip. The electronics store I go to didn't have
any 14 pin IC sockets. Maybe I'll stop by Radio Shack to see if they
do. That and the initial I repairs I made weren't robust enough or
didn't catch everything breaking down.
Fortunately I have five more 74LS08's left!
One thing I noticed while checking traces and other connections on
the board is that not all of the connections read the same value,
though they all fall within certain value groups, as it were. Would
anyone mind telling me what I should be seeing?
Also, can anyone tell me what R17 is? On the schem it's called "RKC
1/8 88 10k". What does it do? Can I get a new one readily?
The reason I ask is because I'm thinking about starting from scratch;
removing the jumps I made before; replacing ICs 30 & 31 and possibly
R17. Since I've had my Polysix and have seen pictures of others'
KLM367s it looks as though mine was/is in pretty rough shape. A lot
of the solder points above the battery area are dull, and some have
visibly corroded. I've checked them all, include a lot of what-are-
they-called? vias? (the areas where the path switches from the bottom
to the top and vice-versa) and all check out, but some look "bad."
Anyway, that's my story. I really prefer to be playing instead of
fixing, but nothing sounds like a ∗real∗ Polysix and thus I'm
addicted. Any input is appreciated.
--- In PolySix@yahoogroups.com, "BrainSlayer" <brainslayer@c...>
wrote:
> sounds like a lfo problem
> ----- Original Message -----
> From: reidar@j...
> To: PolySix@yahoogroups.com
> Sent: Monday, July 19, 2004 1:47 AM
> Subject: Re: [PolySix] Son of a b∗∗∗∗
>
>
>
> That sounds like what my P6 is doing too - like the mod wheel is
fully on.
> Everything is 'bubbling'. I have found that the PWM width
control seems to
> have the best effect on it, but also, if I leave the P6 switched
on for an
> hour or so, it goes away. I'm not an electronics-type, so I
really don't
> have a clue, but the fact that it goes away (usually) after a
long warm-up
> might mean something to some of you?
>
> Reidar
>
PolySix "Digiest" Page: http://www.acc.umu.se/~amber/Poly6
Yahoo! Groups Sponsor
ADVERTISEMENT
------------------------------------------------------------------------------
Yahoo! Groups Links
a.. To visit your group on the web, go to:
http://groups.yahoo.com/group/PolySix/
b.. To unsubscribe from this group, send an email to:
PolySix-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]