Archive of the former Yahoo!Groups mailing list: Discussion about the Korg PolySix synthesizer

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [PolySix] Re: PolySix only works in test mode?

From: <backshall1@bellsouth.net>
Date: 2019-04-23

And if everything seems to be functioning properly with the switch off, then congratulations on a successful board build. The uncalibrated settings must be reasonable enough to not cause any major problems, but you should really go through the calibration steps for the board.
 
Sent: Tuesday, April 23, 2019 5:08 PM
Subject: Re: [PolySix] Re: PolySix only works in test mode?
 
 

Yes, Test is On, so you could flip it around and it would be correct.
Don B.
 
Sent: Tuesday, April 23, 2019 4:41 PM
Subject: Re: [PolySix] Re: PolySix only works in test mode?
 
 

Interesting. Just for clarity, here's a picture of the switch installed on the board. I assumed these switches didn't have to be installed in a specific direction... so I could potentially resolder the switch flipped the other way, and then it would be labeled correctly?