| previous by date | index | next by date |
| topic list | next in topic |
On Thu, Sep 21, 2017 at 2:40 PM, mr gham mrgham@yahoo.com [PolySix] <PolySix@yahoogroups.com> wrote:I did find -13v at
Ic18 .I changed it with a working one ( I tested it before and have -3 v).It partially solved the issue . ThanksI can reach a C.But still I can tune the low or the highBut not together (from the same voice , I can t have c2 and c6 together bra cause the trim high don't allow to go till c6 from the key c6) ... so I can tune right on an octave but not at the whole keyboard ...+ i remarked that VR2 ( tune high , right ?) has no effect when I turn it.Can the issue come from there ?Thanks
Envoyé depuis Yahoo Mail pour iPhoneLe mercredi, septembre 20, 2017, 9:08 PM, mr gham mrgham@yahoo.com [PolySix] <PolySix@yahoogroups.com> a écrit :
ThanksI ll check thatOn Wednesday, September 20, 2017 5:53 PM, "Tony McAdam swamp.gigs@googlemail.com [PolySix]" <PolySix@yahoogroups.com> wrote:
Hi - here's how to check the opto... http://huebnerie.de/blog/2013/ 07/polysix-photocoupler-myths/For the older daughterboard version it's pin 6 on IC18 as it's an 071 instead of an 072....
"This leads to an eady way to check whether a tuning problem is related to the photocoupler circuit at all: measure the voltage on pin 7 of IC18. Within regulation it should be somewhat between -2 and -6 volts, -3 are more normal.
When the loop breaks open due to failure of the photocoupler or related parts, it will be stuck on the maximum negative output, something around -13 volts. There must always be a small current through the LED, otherwise the loop does not work and the TUNE HIGH preset has no effect!"On Wed, Sep 20, 2017 at 3:44 PM, mr gham mrgham@yahoo.com [PolySix] <PolySix@yahoogroups.com> wrote:Hi Tony,This is a new 366
Envoyé depuis Yahoo Mail pour iPhoneLe mercredi, septembre 20, 2017, 4:28 PM, Tony McAdam swamp.gigs@googlemail.com [PolySix] <PolySix@yahoogroups.com> a écrit :What version 366 board is it ? Sounds like an optocoupler problem...