I think you set CN05-7 to 0V using the cutoff knob on the front panel.
Someone wrote that as a comment on my copy of the serv man and
I have done it that way.
--------------------------------------------
On Fri, 7/15/16, jw_dewdney@yahoo.com [PolySix] <PolySix@yahoogroups.com> wrote:
Subject: [PolySix] VCF RESONANCE ADJUSTMENT QUESTION
To: PolySix@yahoogroups.com
Date: Friday, July 15, 2016, 4:44 AM
so... just going through a tune up
(sounds better tuned already after doing the resonance
offsets)... and am a bit confused about which trimmer to
use. For CN05-11 it says to use the vcf res trimmer but for
CN05-7 it just says 'adjust'... ro 0.00v ... does
anyone have a clue what im supposed to ne adjusting here??
thanks much.