thanks! i'll give it a try this week.
- roy
--- trekpilot <
trekpilot@yahoo.com> wrote:
> Hi Roy.
>
> Modifying the effects board for an external IN is
> very simple. All I
> used is a SPDT toggle switch, a mono jack, and a tap
> to the effects
> signal in line. I simply wired the external jack
> tip (signal) line
> into one side of the switch. The other side of the
> switch is the
> synth signal line (for normal operation.) The
> center pole leads to
> the Signal IN line of the effects board (yel/wht
> cn-14). This allows
> you to switch between the synth voices and your
> external signal.
> Don't forget to ground the jack ring connection...I
> simply connected
> it to the other jack grounds.
>
> There are two additional steps: 1) solder a 100ohm
> resistor between
> the external signal jack and the switch lead to
> decrease the signal
> level. Also, it is up to you where you want to
> mount the switch and
> the jack.
> On my setup, I send the signals from my AX80 into
> the Polysix effects
> board. Haven't tried it with recorded audio or
> other signals, but
> this should work for you.
>
> O-------------- Synth
> signal
> To FX signal in--------O
> (KLM-386A CN14 pin 1) O-----/\/\/\--- External
> signal (jack tip)
> 100ohm
>
> Hope I've helped, and have fun with the toys! Let
> me know if you have
> any other questions I can help you with.
__________________________________
Do you Yahoo!?
The New Yahoo! Shopping - with improved product search
http://shopping.yahoo.com