Archive of the former Yahoo!Groups mailing list: Discussion about the Korg PolySix synthesizer

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [PolySix] some defects after battery leak

From: Johan De Vroede <johandevroede@yahoo.com>
Date: 2015-05-28

It is in manual mode. In fact I made 2 films after each other and I only posted the second...
All relevant knobs in the demo are on 0 to be sure that they don't interact... So the whole LFO is on 0. VCO is on triangle. ADSR is on zero and VCA is set to EG. Also the effects are switched off. I will make a second film where you see all the knobs while I demonstrate the defect.


Sent from Yahoo Mail for iPad

At 28-mei-2015 17:25:26, Florian Anwander fanwander@mnet-online.de [PolySix]<'PolySix@yahoogroups.com'> wrote:










Hello



did you start the demo from the "manual" setting or from a progam setting?



It is important, that you do it in manual mode. Otherwise it is not

really possible to deduce the relation between the misbehaviour and and

the parameter settings.

For example the "distortion" coming in at 1:25 might be a fast LFO

modulation.



It would be also helpful if one could see the whole synth all the time.

Use a camera stand and place it above the synth



Florian



Am 28.05.2015 um 17:07 schrieb Johan De Vroede johandevroede@yahoo.com

[PolySix]:

>

> You can find a film that shows the defect that I have on my Polysix.

> You will see that it is the VCF that seem to control the EG. Also the

> VCF doesn't work as it should.... I hope someone can figure out what

> could be the cause and what could fix it.

> VCF defect in Polysix

> <https://vimeo.com/129104997?utm_source=email&utm_medium=clip-transcode_complete-finished-20120100&utm_campaign=7701&email_id=Y2xpcF90cmFuc2NvZGVkfDA0OTQ0MGQ2YjE0MjkzZjdlMWM5YzQwZjNjNTIzZjdmNjZ8NDA1NzQ0MTh8MTQzMjgyNDIxOXw3NzAx>