Archive of the former Yahoo!Groups mailing list: Discussion about the Korg PolySix synthesizer

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [PolySix] Re: Non-working attenuator

From: Bob Grieb <bobgrieb@yahoo.com>
Date: 2014-12-31

I see a capacitor from the base of one transistor in the dual fed by p vol.
If that was shorted, it could stop the p vol from working.
Also check the comparator fed by the reset circuit.
It would short p vol signal to gnd and stop it from working.
I think it is a mute circuit for the output to prevent
Clicks etc when turning on or off.

Bob

From: tuk88@rocketmail.com [PolySix] <PolySix@yahoogroups.com>;
To: <PolySix@yahoogroups.com>;
Subject: Re: [PolySix] Re: Non-working attenuator
Sent: Wed, Dec 31, 2014 10:54:59 AM

 

Thank you Malte,

I checked the cable they are OK. I test the continuity between the KLM368 and the KLM367, it's OK. I will focus at first on the transistor Q24 by changing it. The second way is to change the LM13600N by a LM13700N.

I'll keep you in touch if I have good (or bad) news.

Lucas