Archive of the former Yahoo!Groups mailing list: Discussion about the Korg PolySix synthesizer

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [PolySix] Re: Clone - MG always on by default

From: Bob Grieb <bobgrieb@yahoo.com>
Date: 2014-10-24

In manual mode you should be able to control the op amp buffer outputs by changing the front panel control. If that works, the the cpu is reading the cutoff pot correctly and selecting the right sample and hold channel to send out the voltage.

From: f115@rocketmail.com [PolySix] <PolySix@yahoogroups.com>;
To: <PolySix@yahoogroups.com>;
Subject: Re: [PolySix] Re: Clone - MG always on by default
Sent: Fri, Oct 24, 2014 4:17:12 PM

 

Well I'm afraid I haven't quite got the build right after all. I could really use the help.

- MG is on for sure
- Cutoff not working
- I can't write to patch either.  I tried saving patch A1 as a clean non modulated patch and it didn't pick it up.

I'm baffled. These seem to be somewhat unrelated! Cutoff certainly connects with the MG I/O on CN05 but then tape enable is on CN08.