Archive of the former Yahoo!Groups mailing list: Discussion about the Korg PolySix synthesizer
Subject: Reset Adjustment calibration procedure
From: <rnrjosh@yahoo.com>
Date: 2014-01-02
Quick question, I'm replacing IC5 and IC6 on the KLM-376 board, and I'll need to adjust the Reset Adjustment trimmer. The service manual says "connect a 56k dummy resistor to the KLM-376 2P plug (male)". Does this just mean connect both ends of a 56K resistor to test point TP2 on the board, or is there some mystery "2P plug" on the KLM-376 board that I'm just not seeing? Or should I just turn the trimmer til it seems to work right? :)