| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
Hi all there,
Some updates:
MG LEVEL issue > Solved.
After getting crazy in debugging, I've swapped the 8047-347 (an 8947 with mask rom written on it) with a regular factory 8047. the issue disappeared.
Called the guy who copied the maskrom for me, he gave me another copy an this one works flawless.
------
WRONG SCALING issue:
is still there.
I've bought some NOS VTL5C3/2 photocouplers.
I've replaced the original HTV1510 mounting the VTL5C3/2 upside-down to match pinouts.
This doesn't solve the issue.
Measured the IC18 pin 7, obtaining 0V
After that, i've tried to replace the R39 with a 22K resistor. nope.
Placed back the original HTV1510 and original R39 resistor, measured again the IC 18 pin 7. obtaining 0V just as before.
IC 31 Replaced
IC 18 Replaced
IC 17 Replaced
I have no points to where i'm going nor where to go.
------
PATCHES MEMORY SAVING issue.
I haven't checked it at all, is still there just as before.
---In polysix@yahoogroups.com, <rufushaw@...> wrote:
Hi there,
Some updates.
I've made some swapping tests, and these are the result.
Broken P6 had some issues on panel controls, on octave transpose knob 16' 8' 4' and MG level knob.
I've swapped the KLM367 with a working one, and both these issues disappeared, so, the panel board with knobs is ok and the problem is somewhere on KLM 367.
I've ordered some Vactec VTL5C3/2 to change the PC1 IC, hope this will be enough to restore the voice board.
So questions are:
Which traces / ICs manage the OCTAVE TRANSPOSE switch 16' 8' 4'
Which traces / ICs manage the MG level pot values?
Any help is very much appreciated, thanks.
---In polysix@yahoogroups.com, <rufushaw@...> wrote:Hi all there,I've picked up another Polysix in good external conditions, but dead on the electronic side.It had the common battery leakage on a small area not so bad than others that I've already repaired, so I've restored it at usual,Now some minor issues are still there.Octave scaling is irregular, so, suspecting a faulty HTV1501 photocopupler as written in other topics, I've swapped the voice board with a spare working one, and the issue disappeared, then the issue might be on PC1.I can't understand which spare is better for this IC, someone says VTL5C1, some other says VTL5C3,MG level doesn't works properly.This issue is driving me crazy.Frequency and Delay Pots are working flawless, but once engaged, it's impossible to dim or turn off the LFO modulation effect by turning the "level" pot.The pot itself is working, either the IC2 4051 on control board is working, i've followed the Data and A B C cables for signals routing and they are without any interruption.I've checked the IC6 also, perfect.Connection cables are ok.Tips about where to dig?More than this, it doesn't save patches.I've checked the memory chip's electrical signals, and it seems working properly, giving the same responses than the working one..I have also made the Lithium battery mod as shown in service manual appendix, but there's no way to save patches,although the buttons are working properly.Any help is very much appreciated, thanks.Sorry for my bad english,Bye,