Hi
I do not fully understand your problem. If you are referring to controlling the filter cutoff & resonance using midi then yes there is some stepping as midiCC is limited to 127 steps. This is being addressed and full NRPN support will be in the next release (v1.23) which is still being tested. This will allow 4096 step control. You should not get this stepping using the front panel controls as these are converted to digital at 12 bit (4096 steps).
Because the Polysix uses dedicated hardware for the envelopes, note velocity control is not possible so a different keyboard would not help. I currently have no plans to include OSC as the hardware requirements are different.
MH
--- In PolySix@yahoogroups.com, del_poolp@... wrote:
Hi,
I have installed the Kiwisix on my Polysix, it's a reel good upgrade but :
You have any issue with aliasing with midi control, specially with cuttoff and resonance (use a Antialiasing algo) ?
You have planned a upgrade for keyboard (Fatar sell a good keyboard for DIY) via a expension board ?
You have planned a OSC Support ?
Thanks ;) and you have realised a good job.
--- In PolySix@yahoogroups.com, "kiwitechnics" wrote:
Hi all
I have just joined this group and if anyone has questions or P6 problems I will help where I can and have time. I have put in a section in the install part of the Kiwisix Upgrade manual about common problems that I have encountered with the many P6's I have repaired over the years. This can be downloaded from the kiwitechnics.com web site
MH