Thanks
One of my batteries were dead, now I changed that, and I could actually use one of my dead mobile phones (SonyEricsson K850) battery. However, it was indeed the reset trim that should be adjusted. Now it works fine.
thanks again
Kristoffer
On Nov 10, 2012, at 10:54 PM, klosmon <klosmon@sbcglobal.net> wrote:
> It might need the Reset trim -- see the service manual.
> ~G
>
> On 11/10/2012 12:04 PM, kkristj wrote:
> >
> > Hi All
> >
> > I finally got around to fixing my polysix, usual things caused by
> > battery leaks. Some cut traces around IC30 and 31, most of which in
> > part caused by me unsoldering them, sic. Now I have everything
> > working. Only problem is it takes in excess of 20 seconds to start-up,
> > during which all Leds are on, except the arp led, that is blinking
> > normally.
> >
> > Any comments on this? I believe it may be the switch (SW1) on klm367,
> > but I closed down the polysix, and I would appreciate any comments
> > before I open it up again. When the synth starts up, everything seems
> > to be working normally.
> >
> > thanks
> >
> > Kristoffer
> >
> >
>
> [Non-text portions of this message have been removed]
>
>
[Non-text portions of this message have been removed]