It might need the Reset trim -- see the service manual.
~G
On 11/10/2012 12:04 PM, kkristj wrote:
>
> Hi All
>
> I finally got around to fixing my polysix, usual things caused by
> battery leaks. Some cut traces around IC30 and 31, most of which in
> part caused by me unsoldering them, sic. Now I have everything
> working. Only problem is it takes in excess of 20 seconds to start-up,
> during which all Leds are on, except the arp led, that is blinking
> normally.
>
> Any comments on this? I believe it may be the switch (SW1) on klm367,
> but I closed down the polysix, and I would appreciate any comments
> before I open it up again. When the synth starts up, everything seems
> to be working normally.
>
> thanks
>
> Kristoffer
>
>
[Non-text portions of this message have been removed]