Well, it pretty much sounds like you've narrowed it down to those 4 chips then.
Though I would be worried as to why two voices were killed like that.
BR,
Peter
----- Original Message -----
From: tonezone020
To: PolySix@yahoogroups.com
Sent: Friday, August 31, 2012 7:38 PM
Subject: [PolySix] Re: Voices not working
Hi Peter.
I took the "best" pair (SSM2044+SSM2056) and placed them in different slots - slots are fine.
I then placed the 2 broken 2044s with the best 2056 - no sound with either.
I then placed the 2 broken 2056s with the best 2044 - no sound again.
Any ideas before I replace them ?
Best,
Tony
--- In PolySix@yahoogroups.com, Peter M�rck <peterm@...> wrote:
>
> Hi,
>
> Are you sure both the 2044 and 2056 are dead for both of the dead voices?
> I mean, have you swapped only one with a working voice and verified that the broken voice is still not fixed, PLUS that the previously working voice stops working at the same time?
> Just want to make sure that you don't only test the broken voices and swap chips until it works and then assume all the swapped chipes were toast.
>
> BR,
> Peter
>
>
> ----- Original Message -----
> From: tonezone020
> To: PolySix@yahoogroups.com
> Sent: Friday, August 31, 2012 6:51 PM
> Subject: [PolySix] Re: Voices not working
>
>
>
>
>
> Hi,
>
> I swapped both the SSM2044s and 2056s around for the dead voices and found that all 4 aren't working.
>
> Following on, the remaining SSM2044s have differing volume levels specific to the chip - not slot.
>
> I've reposition the ICs so I have voices 1-4 working and 5/6 not.
>
> Will calibration sort out the sound levels and sonic inconsistencies for the working voices ?
>
> Regards
> Tony
>
> --- In PolySix@yahoogroups.com, Bandit <tonymonta2002@> wrote:
> >
> > SSM 2044 ?�
> >
> >
> > ________________________________
> > From: tonezone020 <swamp.gigs@>
> > To: PolySix@yahoogroups.com
> > Sent: Friday, August 31, 2012 2:06 AM
> > Subject: [PolySix] Voices not working
> >
> >
> > �
> > Hi All,
> >
> > Got a Polysix I've been working on and voices 1 and 3 are not sounding.
> >
> > The leds show they're being triggered.
> >
> > Any suggestions would be greatly appreciated.
> >
> > Thanks in advance,
> >
> > Tony
> >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>
>
>
>
> [Non-text portions of this message have been removed]
>
[Non-text portions of this message have been removed]