Unless I'm looking wrong, R10 is 10k on the schematic. The schematic is
known to be wrong about a few things, however. I don't have any other notes
about this one, and looking back in the archives I don't see anything
popping up about R10.
I'm at work. Can anyone else confirm?
Jed
On Mon, Dec 5, 2011 at 2:24 PM, mopedsimi <mopedsimi@yahoo.com> wrote:
> ∗∗
>
>
> Hi, I just joined the group. Splendid platform in any case!
>
> I just finished two replacement KLM-367 clones and
> have some problems though. At the moment I'm still
> working on the elemination of simple reasons for that.
> (wrong resistor values, bad solder points etc.)
>
> As I have compared the original Board with the clone, I've
> discovered that Resistor R10 on the clone (and in the part list)
> has a different value to the one on the original.
>
> Clone and part list says 10 kOhm but the original one is 120 Ohm.
>
> I'm not shure if that was done on purpose?
>
>
>
[Non-text portions of this message have been removed]