Hi Greg,
You might want to have a look at the values of the components you have used
around the D/A converter section of the board. If you like take a nice
details macro¹ shot of the board and post it where we all can see. I am
sure some eagle eyed person will be able to spot the mistake. The reason one
of the LEDs is stuck on 5 is that the full range of voltages are
unattainable from the D/A converter IC33 over the entire input bit range.
These are checked by the CPU when in test mode.
Cheers,
Andy
On 31/05/2011 23:02, "hotdogfinger25" <gregory.oconnell@gmail.com> wrote:
>
>
>
>
>
> Hello!
> I recently completed one the KLM367 Clones and the MG circuit is not working
> properly. When I turn it on the MG speed slowly ramps up to maximum speed and
> the level is stuck on "10" I did all the bug fixes to no avail. The arpeggio
> speed is normal. Also, during the calibration found in the service manual,
> when you are supposed to make 1 and 8 light up in test mode after switching
> the tape enable on, I can only get 1 and 5 to light up.
>
> or {2 and 5}
> or {3 and 5}
> or {4 and 5)
>
> Has anyone else experienced this problem? Thanks! Greg
>
>
>
>
>
[Non-text portions of this message have been removed]