>Substitute "CN12" for "VR1" and things should be clearer. The regular
>tuning is done with the switch AWAY from the connector.
That would be UP in my case then.
What does this switch actualy do?
I see a change in freq when I switch up or down.
>> -- Play C6 and adjust VR11 to 0 cent --
>> Compared to what must it be 0 cent.
>Well, to C of course. Just connect a regular (electronic) tuner to >the output of the Polysix and observe it. Alternatively you can
>connect your scope to the "SIG OUT" test point (TP1).
I'll put then a reference signal of 440 Hz on my A-channel of the scope and the the B-channel will be connected to TP1 then.
The Polysix is warming up now, and later I'll try to calibrate again.
I will post the result.