Archive of the former Yahoo!Groups mailing list: Discussion about the Korg PolySix synthesizer

Hey group. I've started on the calibration of my first board.However, I seemed to have lost the functionality of the entire Key Assign Mode section. None of the LEDs turn on and they don't seem to respond at all. The Programmer and the arpeggio speed control works just fine. Is this normal? I noticed this after having trouble connecting the 56KOhm resistor on the KLM-376 board and fiddling with it a bit. I assumed that this was somehow the result of calibrating the reset circuit, but now I'm not so sure. Any insight would be great cos I'm at a loss.

I might also add that the Service Manual directions for this calibration are the most confusing and vague instructions I have EVER encountered. :(

Arturo.....

============================================
Arturo Brisindi

[Musics]

mydadvsyours.com | soundcloud.com/arturo00



[Studios]

galleryrecording.weebly.com | arturo00.weebly.com




[Non-text portions of this message have been removed]