Hi Arturo,
I don't know the answer on the switches. Seems like you could do some
continuity testing to figure out if it would work in that configuration.
You can't really get those old-style switches anymore so we designed for new
stock...
On the headers, there is no solution that is as good as the original. You
just can't order any locking connectors like those from anyone. At least
neither Andy nor I could find any last year.
I used breakaway headers like these (they are on the parts list):
http://www.mouser.com/ProductDetail/Molex/22-28-4362/?qs=P7cO%252b%252bFDLzQWa7MZSY2QYA%3d%3d<
http://www.mouser.com/ProductDetail/Molex/22-28-4362/?qs=P7cO%252b%252bFDLzQWa7MZSY2QYA%3d%3d>Best
of luck in your build,
Jed
On Mon, Nov 15, 2010 at 10:15 AM, Arturo B <arturo00@hotmail.com> wrote:
>
>
>
> So I neglected to order the SW1 on both of my Mouser orders because I
> thought I could transplant them from the original boards (I have three
> KLM-367s to replace). To my dismay the original part is a 6 pin DPDT and the
> new board requires a 4 pin SPDT. Can I still use the original part and just
> bend the middle two pins out of the way? I'd like to avoid having to place
> another mouser order and pay $8 shipping for $3 worth of parts ;)
>
> btw, what was the dilly with the headers? There was some discussion on here
> recently concerning those. Were adequate replacements found? That was by far
> the hardest part of this project, transplanting those damn headers from the
> old board!...that and transplanting the trim pots and fitting the originals
> into the new board. But I made it work. :)
>
> A.....
>
> ============================================
> Arturo Brisindi
>
> [Musics]
> mydadvsyours.com | soundcloud.com/arturo00
>
> [Studios]
> galleryrecording.weebly.com | arturo00.weebly.com
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
[Non-text portions of this message have been removed]